Knotless netting

I have been off work today with a cold and asthma, so needed a simple project I could do the inside. About a year ago I was shown the principles of knot less netting and decided to try and make a carrier for a large bottle.

I have used para cord below to show how the principles of this method work. Loop the cord (I used my fingers as a gauge) around a gauge and then thread the cord three times around it’s self and then make the next loop and repeat the above.

I used gardeners hemp, threaded on a bone needle to make the bottle carrier and used two fingers as a gauge for the netting size.

For the base I reduced the netting size to one finger and tied the last row of mesh together to finish the carrier off. I made the carrying strap using a four strand round plat.

The benefit of this knotless netting carrier is that you can undo the string if you need it or net a different item to meet you needs.


The Roycroft Snowshoe

In England it is now rare for us to get sufficient snow fall to use snowshoes, but in Lapland they will prove very useful.While on a Winter Wilderness Survival Course taught by Mors Kochanski in 2006, I learned to make Roycroft Snowshoes.On the course we used young Spruce, but here I am using Willow (Hazel also works well).

Gather five sticks roughly the same length as you’re height.They should be about the same diameter as a pencil at the narrow end.Remove any side branches and then the bark.

Once all five are completed they should be tied together about two fingers width from the end (I use a constrictor knot).

Now cut a piece of wood to roughly the same dimensions as a bow-drill hearth and the span of your hands in length.Balance the snow shoe on your finger to find the mid-point of the shoe, and then place your heel at this point and the piece of wood beneath the ball of your foot.Now lash the piece of wood in this position to all five stick (I used a Jam Knot and cut notches into the piece of wood to help hold the lashings in place.

Tie the thick ends of the sticks (the back of the snowshoe) together, leaving a space the width of your finger between each (I tied four overhand knots to act as spacers). Now secure another block of wood where your heel rests on the shoe (using the same method described above), which should be about two fingers in front of the pivot point.

Now using either a piece of ribbon, cord or elastic lash around the shoe and over your toes, tying the two ends on top of your toes as shown below.

After tying the knot on top of the toes, bring the two ends around the back of the heel and tie off using a reef knot (this knot is obscured by the bottom of my trouser leg in the picture below).This will allow your foot to pivot on the shoe as you walk, but still keep the snowshoe on.

The snowshoe is easier to use if the tip of the shoe curves up at the end, so tie a cord between the tip and the block of wood and leave until the wood has dried out.

Repeat the process for the second snowshoe and hope there is sufficient snowfall to be able to test them.